Tag: Water Heater

Tips On What To Do If You Have A Water Heater Leak

Water leakage in the house can happen anytime, and as a homeowner, you need to be fully prepared for such circumstances. Leakage in the water heater does not always mean that the entire unit needs to be replaced but, you need to fix it immediately. A water heater leakage needs to be taken seriously since a little water leakage can cause severe accidents. In this article, we have shared a few methods to detect water leakage and what to do next. If the situation is out of control then you need to hire a team of plumbers Carlsbad or a plumbing repair Carlsbad agency to get the issue fixed.

What to do in the first place?

The very first thing that one should check is where the leakage has actually occurred. If you see some water below the heater, wipe it off as it might not be coming out of any leakage. After wiping off the area, look for any other signs of leakage. Check each and every fitting of the heater. Now If you are unable to find out any leakage, place tissue or a towel under the heater where you found the water and check after a few hours whether the water is still accumulating there or not. Once you find out the location of the leakage, you can either professional Carlsbad plumber and get the issue checked or follow the below-mentioned steps.

What are the steps to follow in case there is a water heater leakage?

Step 1: Once you find out that there is water leakage, the very first thing you should do is switch off the water heater immediately to prevent any kind of accident. If your water heater has a gate-type valve turn it off clockwise, if the valve is ball type then turn it off at 180 degrees.

If you find out that the valve is broken, then you need to turn off the main water supply and call a professional water leak Carlsbad plumbing agency immediately.

Step 2: Turn off the main power supply. For example, if you have an electric water heater, then you are recommended to shut the power off at the breaker by flipping the breaker. If you have a gas water heater then you are recommended to shut the gas supply off by closing the gas valve.

Step 3: The final step is to determine the exact location of the leakage.

The following units you need to check to find out the exact location of the leakage:

• The inlet & the outlet that is where the pipes are connected to the water heater.
• The pressure relieving valve.
• The thermostat setting needs to be checked.
• The inbound water pressure.
• The bottom of the water heater.
• The drain valve (located at the bottom of the tank).

Conclusion

A water heater leakage issue cannot be fixed without experienced hands. You can follow the above mentioned points to find out the leakage, but once the initial steps are done you need to call a professional plumbing repair Carlsbad agency and get the issue fixed within no time.